Snowflake effect from painting

1, lightly spray can form icing a lot of snow-like effect.

2, use a flat shovel could strike, and then wipe again with a neutral cleaning agent can recover.

3, can eliminate the residual gas after use clean the air cleaner cover.

1, sprayed on the surface of dust, grease, wax mark, mildew etc to be cleared in advance, allow it to fully dry then spray.

2, with the need to fully shake the container before, heard the sound of stirring ball shook for about 30 seconds before they can even after spraying. Spraying process also needs to constantly shake mix.

3, when sprayed, painted between the surface and the nozzle to maintain spacing of approximately 20~40cm. Small particles finer spacing, spacing large enough, with coarse particles.

4, spray painted, can try spraying in inconspicuous places, observing the color, dry and effects on substrate of a spray.

5, at first in an inconspicuous place try to spray it, look at the color, coating, drying performance and substrate affect the confirmation of a spray.

6, once not spraying too thickly, moving parallel to the spray paint cans and painted plane, and each time you spray a little thinner, spray evenly back and forth two or three times.

7, each time after spraying, spray bottles upside down spraying must be 2 seconds or so, remaining paint in discharging the catheter to prevent blockage of catheters. Air to the nozzle after spraying to wipe clean cover and placed after save it for reuse.

① do not use outside purpose place.

② spraying above 35 degrees where this product is easy to melt, so is not suitable for high temperatures or hot air directly to the place.

③ dried in direct contact with the product is easy to fall off, so other articles cannot be placed on top of it, and easier access to other articles are not suitable for use.

II is not suitable for bearing the plastic film on the glass surface.

⑤ on spray on the plastic, paper, wood surface, there may not be easy to remove and clean.

⑥ area of spraying, drying time according to the spray method, substrate, weather conditions, such as the different changes.

⑦ aerosol can upside down may not be sprayed.

Remove method:

1. with a small shovel shovel it away and then wipe clean with a cloth with volatile solvents.

2. easy to volatile solvents corrosion plastic surfaces, decorative surface with a neutral cleaning agent to clean.